Showing posts with label no start. Show all posts
Showing posts with label no start. Show all posts

Thursday, November 29, 2012

CAR NO START: ENGINE NOT TURNING OVER:


CAR NO START PROBLEMS:-----
           
Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

           
From start to end troubleshooting these problem i suggest you to check the help link below and follow its procedure:-----

Mostly all types of car no start problems are discussed here with solutions.

           

What to Do When Car Turns Over But Won't Start?
 --------------

Car takes time to Crank and start?
------------

Car will not turn the ignition to start?
-----------

Car starting issues? ( Part 1)
------------

Car Starting Problems( Part 2)
-------------

Car not starting? ( Part 3)
---------------

Car will not start? ( Part 4)
-----

Car suddenly died and won’t start? ( Part 5)
----------





Car won't start without hitting the gas pedal?
----------------

Car only starts when gas pedal is pressed?
----------

1991 Toyota Trecel: Engine Starts fine but dies when gets Warm?
----------

1994 Toyota Pickup: Starts fine but dies in few seconds?

---------

1999 Chrysler Cirrus: 8 IGN Fuel Starter Fuse Blows?
-----------

2001 Toyota Camry: No start After replacing Battery?
----------

1989 Toyota Pickup Truck: Turns over but not start?
--------------

Car dead and will not Start?
--------

1995 Lexus LS400: Running Hot?
----------

2001 Toyota Prius will not start?
---------

1996 Jeep Grand Cherokee: Engine will not start?
-------------

Mitsubishi will not start
---------

Car turns over, but only starts, if starter is jumped?
----------------

Engine turns over but will not fire or start?
----------

Vehicle Starts, Runs and Loses Power
--------

Intermittent starting issues on Volvo 760?
------------

Car Not Starting After Floods?
---------

Brake warning light comes on and car will not start intermittently?
------------

Headlights flickering and car hesitates to start?
-----------

Mercedes Benz 300TD wagon Diesel model will not start?
--------------

Car cranks, has spark but will not start?
---------

Fuel pressure and spark is good but ford escort will not start?
--------

Dodge vehicle will not start after sitting overnight?
--------------

Engine hard to start after gas refill?
---------

After disconnecting and reconnecting battery Mercedes will not start?
------------

1997 Oldsmobile Cutlass Ciera: The Engine cranks but not start?
---------

Distributor got wet causing no start on Lincoln car?
-------------

Multiple problems on car: Car runs hot, A/C blows hot and car starts surging?
------------

Squealing at start up on car?
-------------

2000 Toyota Tacoma: OBD Code P1300 Engine Starts and Quits Running?
------------

2011 Lexus ES350: No start?
---------------

After replacing Harmonic balancer car will not start
------------

2001 Toyota 4Runner: Vehicle started skipping Badly?
------------

2002 Toyota RAV4: Started Skipping and Stuck in gears?
--------

Car is starting but not turning over?                   
--------

Engine cranks but will not start?
--------

Landcruiser prado won't start
 ----------

2007 ford expedition engine cranks but wont start
----------

Mazda MPV cranks but will not start?
---------

MAZDA MPV WILL CRANK BUT NOT TURN OVER TO START?
--------

Vehicle Cranks Fast but Won't Start
-----------

Nissan car will not start?
----------

Delay starting on Toyota Prius?
-------

Honda car will not start intermittently?
--------

Toyota car will not start?
-----------

Jeep starts with key in on position?
------------

Car starts and cuts off immediately?
-----------

Volvo 760 engine cuts off frequently while driving?
-------------

Ford explorer will not start after replacing computer ECM ?
-----------

Car will not start security lock out?
----------

Car will not start just a clicking noise?
----------

After replacing glow plugs Truck will not start?
----------

Truck is hard to start and Emits smoke while starting?
---------

Engine cuts out at 3000 RPM?
------------

Car turns over but will not start, only makes clicking sound?
-----------

Car won’t start when cold?
-----------

Car won't start after sitting overnight?
------------

1997 jetta lacks power
 ---------------

Car loses power while acceleration?
--------

KeyFob will open the doors but not start on BMW?
----------

Theft indicator not letting car to start?
----------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
----------

Engine overheated then car will not start?
----------

2002 Citroen Synergie will not start
------------



The list will get updated soon with more help links ........................
Visit Again
These will help.
Thanks.

Friday, November 11, 2011

Precautions before inspecting BMW airbag system?


Precautions


Go through the details:----

Disconnect and isolate the battery negative cable before beginning any airbag system component diagnosis, testing, removal, or installation procedures. Allow system capacitor to discharge for two minutes before beginning any component service. This will disable the airbag system. Failure to disable the airbag system may result in accidental airbag deployment, personal injury, or death.
Do not place an intact undeployed airbag face down on a solid surface. The airbag will propel into the air if accidentally deployed and may result in personal injury or death.
When carrying or handling an undeployed airbag, the trim side (face) of the airbag should be pointing towards the body to minimize possibility of injury if accidental deployment occurs. Failure to do this may result in personal injury or death.
Replace airbag system components with OEM replacement parts. Substitute parts may appear interchangeable, but internal differences may result in inferior occupant protection. Failure to do so may result in occupant personal injury or death.
Wear safety glasses, rubber gloves, and long sleeved clothing when cleaning powder residue from vehicle after an airbag deployment. Powder residue emitted from a deployed airbag can cause skin irritation. Flush affected area with cool water if irritation is experienced. If nasal or throat irritation is experienced, exit the vehicle for fresh air until the irritation ceases. If irritation continues, see a physician.
Do not use a replacement airbag that is not in the original packaging. This may result in improper deployment, personal injury, or death.
The factory installed fasteners, screws and bolts used to fasten airbag components have a special coating and are specifically designed for the airbag system. Do not use substitute fasteners. Use only original equipment fasteners listed in the parts catalog when fastener replacement is required.
During, and following, any child restraint anchor service, due to impact event or vehicle repair, carefully inspect all mounting hardware, tether straps, and anchors for proper installation, operation, or damage. If a child restraint anchor is found damaged in any way, the anchor must be replaced. Failure to do this may result in personal injury or death.
Deployed and non-deployed airbags may or may not have live pyrotechnic material within the airbag inflator.
Do not dispose of driver/passenger/curtain airbags or seat belt tensioners unless you are sure of complete deployment. Refer to the Hazardous Substance Control System for proper disposal.
Dispose of deployed airbags and tensioners consistent with state, provincial, local, and federal regulations.
After any airbag component testing or service, do not connect the battery negative cable. Personal injury or death may result if the system test is not performed first.
If the vehicle is equipped with the Occupant Classification System (OCS), do not connect the battery negative cable before performing the OCS Verification Test using the scan tool and the appropriate diagnostic information. Personal injury or death may result if the system test is not performed properly.
Never replace both the Occupant Restraint Controller (ORC) and the Occupant Classification Module (OCM) at the same time. If both require replacement, replace one, then perform the Airbag System test before replacing the other.
Both the ORC and the OCM store Occupant Classification System (OCS) calibration data, which they transfer to one another when one of them is replaced. If both are replaced at the same time, an irreversible fault will be set in both modules and the OCS may malfunction and cause personal injury or death.
If equipped with OCS, the Seat Weight Sensor is a sensitive, calibrated unit and must be handled carefully. Do not drop or handle roughly. If dropped or damaged, replace with another sensor. Failure to do so may result in occupant injury or death.
If equipped with OCS, the front passenger seat must be handled carefully as well. When removing the seat, be careful when setting on floor not to drop. If dropped, the sensor may be inoperative, could result in occupant injury, or possibly death.
If equipped with OCS, when the passenger front seat is on the floor, no one should sit in the front passenger seat. This uneven force may damage the sensing ability of the seat weight sensors. If sat on and damaged, the sensor may be inoperative, could result in occupant injury, or possibly death.

This details will help.

----------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------

Disarming the System?


  1. Place the ignition switch in the OFF position.
  2. Disconnect the negative battery terminal and cover the battery terminal to prevent accidental contact.
  3. Once the battery has been disconnected, if the electrical connector for the air bag gas generator is not disconnected, you must wait for a period of:

    30 minutes for vehicles manufactured before 9/93
    5 seconds for vehicles manufactured after 9/93
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Place the ignition switch in the OFF position.
  3. Disconnect the negative battery terminal and cover the battery terminal to prevent accidental contact.
  4. Once the battery has been disconnected, wait for a period of approximately 10 minutes allowing the capacitor in the control unit to discharge.
  5. When repairs are completed, connect the negative battery cable.
  1. Place the ignition switch in the OFF position.
  2. Disconnect the negative battery terminal and cover the battery terminal to prevent accidental contact.
  3. Once the battery has been disconnected, wait for a period of approximately 10 minutes allowing the capacitor in the control unit to discharged. Once the capacitor is discharged, a trigger pulse cannot be generated inadvertently.
  4. Disconnect the crash sensors in the engine compartment.
  5. Remove the lower cover of the steering column and disconnect the orange connector.

--------
For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------


454 gm motor smokes when oil is added ?

I believe the seals may be dried out ,one of the user got same problem and he noticed smoke coming out from plug number 7 when oil was added.

The seals are no doubt dryrotted or missing. I had 1 truck that had faulty seals at 13000 miles. The sludge is not as drastic as you may be visualizing. The extreme low mileage may have caused some buildup around the returns. The reason for #7 is that it is the lowest area, so the oil pools and rises around those valve stem seals. You can certainly try to add on the other side if you have access and see what happens. All of the seals will be in need of replacement but that back cylinder is subject to more heat and could have deteriorated that seal over the rest.
In your case also the problem may be similar,check out this possibilities,this will help.
Thanks.

For more car related problem troubleshooting:---

This are the sections, you can go through and click the link to read its troubleshooting.

---------

The car will not start?

-----------------

Car will not crank?


-----------

Car has no spark?


-------------

How to troubleshoot car battery?

-----------------

How to test starter solenoid?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html

--------------------

How to test cars starter?

http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html

How to replace starter in car?



-----------

car will turn over but will not start?



-----------------

Car wont start?


----------